Panasonic WV-NS202A Installation Manual page 14

Wire through a hole in the ceiling
Step 1
Fix the provided camera mount bracket with four
optional fixing screws (M4 or M6).
There should be no obstacles such as wall in a range of
100 mm away from the center point of the mount brack-
et.
Shooting direction (FRONT)
Step 2
Make a hole in the ceiling to pass the cables through.
Make a hole 25 mm in diameter. The center point of the
hole should be located approx. 75 mm away from the
center point of the mount bracket.
Wiring hole
(φ25 mm)
14
Screw (M4)
Screw (M6)
100 mm or more away from
obstacles such as wall
Step 3
Insert the SD memory card into the SD memory card
slot. Refer to page 21 for how to insert the SD memory
card.
Step 4
Attach the safety wire fixed with the camera mount
bracket to the camera.
After attaching the safety wire to the camera, pull the
safety wire and confirm that the ring at the end of the
safety wire is securely hooked on the safety wire holder.
Step 5
Connect cables to the EXT I/O terminals, the MIC IN
connector, the AUDIO OUT connector and the MONI-
TOR OUT connector.
Microphone in connector
External I/O terminals
10BASE-T/
100BASE-TX
POWER
LINK ACT INITIAL 4 3 2 1
SET
MIC IN
12V IN
EXT I/O
• External I/O terminals
Connect external devices.
When connecting an external device, first remove 9 mm
– 10 mm of the outer jacket of the cable and twist the
cable core to prevent a short circuit.
Safety wire
Safety wire holder
Audio output connector
Monitor out connector
AUDIO OUT MONITOR OUT