Panasonic WV-NS202A Installation Manual page 23

Step 1
Start the Panasonic IP setting software.
Step 2
Click the [IP setting] button after selecting the MAC
address/IP address of the camera to be configured.
Note:
When using a DHCP server, the IP address
assigned to the camera can be displayed by click-
ing the [Refresh] button of the IP setting software.
Step 3
Complete each network setup item and click the
[Apply] button.
Note:
When using a DHCP server, it is possible to set
"DNS" to "AUTO".
Important:
• It may take around 30 seconds to completely
upload the settings of the camera after clicking the
[Apply] button. The settings may be invalidated
when the DC 12 V power supply is cut or when the
LAN cable is disconnected before completing the
upload. In this case, perform the settings again.
• When using a firewall (including software), allow
access to all UDP ports.
23