Panasonic WV-NS202A Installation Manual page 16

Step 7
Fix the camera on the mount bracket using the provid-
ed camera fixing screw.
Recommended tightening torque:
0.68 N·m {7.0 kgf·cm}
Fixing screw
(standard
accessory)
Step 8
Connect the cables to the network connector and the
power inlet.
Important:
• Do not touch the camera in the process of initializa-
tion. Otherwise, it may fail to initialize and may
cause malfunction.
• When the camera has been inadvertently touched
and moved after the initialization is complete, the
preset positions may be inaccurate. In this case,
use the position refresh function or restart the cam-
era to correct the preset positions.
Refer to the network operating instructions (PDF)
for further information.
Network connector
DC 12 V power terminals
10BASE-T/
100BASE-TX
LINK ACT
• Network connector
Connect a LAN cable (category 5 or better) to the net-
work connector.
When the LAN cable connected to the network connec-
tor of the camera is connected to a PoE device (such
as a PoE hub), power will be supplied to the camera
through the LAN cable.
When using a PoE device, refer the following notice.
16
INITIAL POWER 4 3 2 1
SET
MIC IN AUDIO OUT MONITOR OUT
12V IN
EXT I/O
Important:
• Use all 4 pairs (8 pins) of the LAN cable.
• The maximum cable length is 100 m.
• Make sure that the PoE device in use is compliant
with IEEE802.3af standard.
• When connecting both the DC 12 V power supply
and the PoE device for power supply, PoE will be
used for power supply.
• When disconnecting the LAN cable once, recon-
nect the cable after about 2 seconds. When the
cable is connected before 2 seconds have passed,
the power may not be supplied from the PoE
device.
• DC 12 V power terminals
Connect to a DC 12 V power supply.
q Remove 3 mm – 7 mm of the outer jacket of the
power cord from a DC 12 V power supply and twist
the core of the power cord to prevent a short cir-
cuit.
Then, loosen the screw of the provided DC 12 V
power cord plug and attach the power cord from
the DC 12 V power supply.
Tighten the screw of the DC 12 V power cord plug
to fix to the attached cable.
Specification of cable (wire): AWG #16 - #28
w Insert the DC 12 V power cord plug into the DC
12 V power terminals.
DC 12 V power cord plug
(standard accessory)
+
–
Important:
• Make sure that the power cord from a DC 12 V
power supply is fixed to the provided DC 12 V
power cord plug firmly.
Make also sure that the DC 12 V power cord plug
is inserted into the DC 12 V power terminals of the
camera firmly.
Otherwise, it may damage the camera or cause
malfunction.
• When the power of the camera is turned on, the
camera will start panning and the position will auto-
matically be initialized.
Single core, twisted
Approx. 3 mm - 7 mm