Table of Contents
Advertisement
Installations/Connections
Caution:
• A READILY ACCESSIBLE DISCONNECT DEVICE SHALL BE INCORPORATED TO THE EQUIPMENT POWERED BY
12 V DC POWER SUPPLY.
• ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY (UL 1310/CSA 223) or LIMITED POWER SOURCE (IEC/EN/
UL/CSA 60950-1).
Before installation, prepare the following
There are 4 methods to install the camera to a ceiling or wall as described below. Prepare the required devices and cables
for each installation method before starting the installation.
<Installing the camera to a ceiling that has adequate structural strength>
Use the camera mount bracket (accessory).
• Procure 4 screws (M4) to secure the camera mount bracket (accessory).
• Select screws according to the material of the ceiling that the camera will be mounted to.
• The minimum required pull-out capacity of a single screw is 196 N {44 lbf} or more.
• When mounting the camera on a concrete ceiling, use an AY plug bolt (M4) for securing.
(Recommended tightening torque: 1.6 N·m {1.18 lbf·ft})
<Installing the camera to a ceiling that has inadequate structural strength such as plaster board ceiling>
The area of the ceiling that the camera will be installed to must be sufficiently reinforced, or the optional ceiling mount
bracket for the camera (WV-Q105, weight approx. 0.15 kg {0.33 lbs}) must be used.
• When using the ceiling mount bracket (WV-Q105), prepare 2 anchor bolts (M10) to secure the bracket to a roof space
(including 1 for securing the safety wire).
• The minimum required pull-out capacity of a single screw or anchor bolt is 5 times or more of the total weight of the
camera and all of its parts.
• Existing anchor bolts can be used to secure the safety wire to a ceiling. If existing anchor bolts are used, there may not
be enough supplied nuts to be used with all the anchor bolts. In this case, procure the required nuts separately.
<Installing the camera embedded to a ceiling that has inadequate structural strength such as plaster board ceiling>
The area of the ceiling that the camera will be installed to must be sufficiently reinforced, or the optional ceiling embedding
bracket for the camera (WV-Q126A, weight approx. 1.2 kg {2.65 lbs}) must be used.
• When using the ceiling embedding bracket (WV-Q126A), prepare 2 anchor bolts (M10) to secure the bracket to a roof
space (including 1 for securing the safety wire).
• The minimum required pull-out capacity of a single screw or anchor bolt is 5 times or more of the total weight of the
camera and all of its parts.
• Existing anchor bolts can be used to secure the safety wire to a ceiling. If existing anchor bolts are used, there may not
be enough supplied nuts to be used with all the anchor bolts. In this case, procure the required nuts separately.
<Installing the camera to a wall>
Use the wall mount bracket (WV-Q119, weight approx. 0.65 kg {1.43 lbs}).
• Procure 4 screws (M4) to secure the wall mount bracket (WV-Q119) to the wall.
• Select screws according to the material of the wall that the camera will be mounted to.
• The minimum required pull-out capacity of a single screw or anchor bolt is 196 N {44 lbf} or more.
When installing the camera using the ceiling mount bracket, the ceiling embedding bracket, or the wall mount bracket,
refer to the instructions included with those optional accessories.
17
Advertisement
Table of Contents
