Subscribe to Our Youtube Channel
Related Manuals for TQ MB-COME6-1
Summary of Contents for TQ MB-COME6-1
- Page 1 User's Manual l MB-COME6-1 UM 0100 l © 2016 TQ-Group Page i MB-COME6-1 User's Manual MB-COME6-1 UM 0100 2016-01-29...
-
Page 3: Table Of Contents
User's Manual l MB-COME6-1 UM 0100 l © 2016 TQ-Group Page i TABLE OF CONTENTS ABOUT THIS MANUAL....................................1 Copyright and Licence Expenses ................................1 Registered Trademarks....................................1 Disclaimer........................................1 Imprint..........................................1 Service and Support....................................1 Tips on Safety .......................................2 Symbols and Typographic Conventions..............................2 Handling and ESD Tips ....................................2 Naming of Signals.......................................3... - Page 4 User's Manual l MB-COME6-1 UM 0100 l © 2016 TQ-Group Page ii TABLE OF CONTENTS (continued) MECHANICS ....................................... 20 Dimensions ........................................ 20 Protection Against External Effects ..............................20 SOFTWARE........................................21 System Resources ....................................21 5.1.1 I C Bus .......................................... 21 5.1.2...
- Page 5 User's Manual l MB-COME6-1 UM 0100 l © 2016 TQ-Group Page iii ILLUSTRATION DIRECTORY Illustration 1: Block Diagram MB-COME6-1................................6 Illustration 2: MB-COME6-1, Top ....................................8 Illustration 3: MB-COME6-1, Bottom ..................................9 Illustration 4: RJ45 Connectors X8, X9 .................................. 11 Illustration 5: RS232 D-SUB Connector X6................................12 Illustration 6: RS232 Header X24 ....................................
-
Page 7: About This Manual
/ declared. Registered Trademarks TQ-Systems GmbH aims to adhere to the copyrights of all the graphics and texts used in all publications, and strives to use original or license-free graphics and texts. All the brand names and trademarks mentioned in the publication, including those protected by a third party, unless specified otherwise in writing, are subjected to the specifications of the current copyright laws and the proprietary laws of the present registered proprietor without any limitation. -
Page 8: Tips On Safety
Handling and ESD Tips General handling of your TQ-products The TQ-product may only be used and serviced by certified personnel who have taken note of the information, the safety regulations in this document and all related rules and regulations. A general rule is: do not touch the TQ-product during operation. This is especially important when switching on, changing jumper settings or connecting other devices without ensuring beforehand that the power supply of the system has been switched off. -
Page 9: Naming Of Signals
User's Manual l MB-COME6-1 UM 0100 l © 2016 TQ-Group Page 3 Naming of Signals A hash mark (#) at the end of the signal name indicates a low-active signal. Example: RESET# If a signal can switch between two functions and if this is noted in the name of the signal, the low-active function is marked with a hash mark and shown at the end. -
Page 10: Introduction
INTRODUCTION The COM Express™ mainboard MB-COME6-1 is a carrier board for COM Express™ modules with Type 6 pinout. It can be used for embedded computers or as evaluation platform for COM Express™ modules. In combination with a standard COM Express™... -
Page 11: Accessories
User's Manual l MB-COME6-1 UM 0100 l © 2016 TQ-Group Page 5 Accessories • COMSET-HDD Mounting Set for 2.5’’ HDD/SSD on the MB-COME6-1 • RISER-COME-PCIE Riser for 1 × PCIe; PCIe card is below mainboard • RISER-COME-2 × PCIE Riser for 2 × PCIe; PCIe cards are beside mainboard •... -
Page 12: Functional Specification
UEFI-shell active; no keyboard, no mouse, no mass storage device, no Ethernet cable etc. connected). The maximum input current of the MB-COME6-1 is limited to 5 A by a fuse. The devices connected to the carrier should not exceed 40 W. -
Page 13: Environmental Specification
UART. The connected serial ports operate with standard serial port drivers. 3.4.3 HD-Audio Codec The MB-COME6-1 is equipped with a VIA VT1802P High Definition Audio Codec with a stereo Class D Amplifier with 2 W RMS output power per channel. 3.4.4 I C Test Devices The MB-COME6-1 is equipped with an EEPROM and an I/O Expander at the general purpose I C bus (COM Express™... -
Page 14: Connectors And Interfaces
User's Manual l MB-COME6-1 UM 0100 l © 2015 TQ-Group Page 8 Connectors and Interfaces X12: headphone / X15: SIM X37: CFAST X10: Power In X11: Display X20: Front panel microphone card socket socket 12 V DC Backlight connector X19: SPI flash socket X1: COM Express™... -
Page 15: Illustration 3: Mb-Come6-1, Bottom
User's Manual l MB-COME6-1 UM 0100 l © 2016 TQ-Group Page 9 X29: X30: X27 / 28: X31: MicroSD card socket LVDS Mini PCIe Speaker out socket right and left X32: Display Backlight X33: COM Express™ GPIO header X34: Smart battery... -
Page 16: Power Supply
DisplayPort The MB-COME6-1 supports two DisplayPort interfaces. The support of adapters from DP to HDMI, DVI or VGA depends on the combination of the COM Express™ module and the adapter used. The combination of some modules with some adapters might not work. -
Page 17: Gigabit Ethernet
1 × RS422 (on-board header) The COM Express™ Specification does only provide signal definitions for RX and TX lines for the serial interface. Due to the TQ- flexiCFG feature the serial ports can be configured to route the handshake signals to free pins on the COM Express connector. -
Page 18: Illustration 5: Rs232 D-Sub Connector X6
RS422 TX+ RS422 RX+ – RS422 TX– RS422 RX+ – – Illustration 7: RS422 Header X25 Not available since signal is not defined in COM Express™ specification. Only available when the TQ flexiCFG feature is available on the COM Express™ module. -
Page 19: Lvds
The MB-COME6-1 has an on-board EDID EEPROM to store display specific timing information. This EEPROM can be programmed with an external I C programmer. If the programmer supports a 3.3 V output voltage the MB-COME6-1 can be programmed without any additional power supply. In this case no COM Express™ module should be connected to the carrier. -
Page 20: Mini Pcie Socket
VCC_SWITCHED Backlight voltage output A voltage of up to 30 V can be supplied at this pin. Connect Pin 1 and 2 to use the 12 V of the MB-COME6-1 for the backlight. X32: Backlight connector Connector type: Hirose DF19G-20P-1H Mating connector: e.g. -
Page 21: Sata Interfaces
User's Manual l MB-COME6-1 UM 0100 l © 2016 TQ-Group Page 15 3.5.8 SATA Interfaces The MB-COME6-1 supports two SATA interfaces: • One mSATA socket for mSATA-SSDs • One connector for 2.5’’ HDD/SSDs, which can be mounted on the carrier with a mounting set The maximum transfer rates of these interfaces mainly depend on the COM Express™... -
Page 22: Sd Card Socket (Micro Sd)
The Signals for SDIO on COM Express™ modules can also be used as GPIO signals. Please ensure that the module is configured for SDIO-usage of these pins. 3.5.10 Audio The MB-COME6-1 is equipped with an audio codec to support following audio features: • Headphone out •... -
Page 23: Fan Connectors
5 V Fan Connector X18 3.5.12 Riser Interface The MB-COME6-1 is equipped with a card edge connector for extension purposes. Up to two PCIe cards can be connected to this interface with adapters. For further information about the Riser interface, please contact TQ-Systems GmbH. -
Page 24: Front Panel Connector
SMBus and I C Header The MB-COME6-1 is equipped with a header, the user can easily access to SMBus. The I C Bus (in the TQ-flexiCFG block) can also be accessed here. On this header there is also the possibility to set 2 jumpers for the BIOS disable signals of the module. This header is only used for debug purposes. -
Page 25: Spi Flash Socket
SPI Flash Socket The MB-COME6-1 is equipped with a socket for SPI flashes. This is useful if a BIOS update fails or for BIOS development purposes. SPI-Flashes with SO8W package can be inserted. Whether a distinct flash device is supported depends on the COM Express™... -
Page 26: Mechanics
The following illustration shows the MB-COME6-1. Illustration 21: MB-COME6-1 Please contact support@tq-group.com for more details about 2D/3D Step models. Protection Against External Effects The MB-COME6-1 is not protected against dust, external impact and contact (IP00). Adequate protection has to be guaranteed by the surrounding system. -
Page 27: Software
5.1.2 SMBus The SMBus (System Management Bus) on the MB-COME6-1 is connected to the PCIe clock buffer, the MiniPCIe socket and to the Riser interface. It is accessible on the SMBus and I C header. The following table shows the I C address mapping for the COM Express™ SMBus port: Table 19: I C Address Mapping COM Express™... -
Page 28: Safety Requirements And Protective Regulations
Measurements for ESD protection have to be done with the electronic parts mounted in a housing. Since TQ- Systems GmbH does not offer a housing for the MB-COME6-1 so far, no special preventive measures were done up to now. -
Page 29: Appendix
User's Manual l MB-COME6-1 UM 0100 l © 2016 TQ-Group Page 23 APPENDIX Acronyms and Definitions The following acronyms and abbreviations are used in this document. Table 20: Acronyms Acronym Meaning AT Attachment BIOS Basic Input/Output System Central Processing Unit... - Page 30 User's Manual l MB-COME6-1 UM 0100 l © 2015 TQ-Group Page 24 Table 20: Acronyms (continued) Acronym Meaning Multimedia Card mSATA Mini-SATA MTBF Mean operating Time Between Failures Not Connected Output Open drain output OpROM Option ROM Personal Computer Printed Circuit Board...
-
Page 31: References
User's Manual l MB-COME6-1 UM 0100 l © 2016 TQ-Group Page 25 References Table 21: Further Applicable Documents and Links No. Name Rev. / Date Company (1) PICMG® COM0 COM Express™ Module Base Specification Rev. 2.1, May 14, 2014 PICMG®... - Page 33 TQ-Systems GmbH Mühlstraße 2 l Gut Delling l 82229 Seefeld info@tq-group.com www.tq-group.com...
Need help?
Do you have a question about the MB-COME6-1 and is the answer not in the manual?
Questions and answers