TQ Arm STKaRZG2x Quick Start Manual

Quick-Start-Guide STKaRZG2x
Arm® architecture
A
CONNECT HOST PC AND STKaRZG2x
Use the supplied USB cable (USB2.0 ST-A / Micro-B) to connect
Debug-USB (X9) of the STKaRZG2x to a USB port of your host PC.
RUN TERMINAL EMULATOR AND
CONFIGURE SERIAL PORT
Run your favourite terminal emulator on the host PC (we
Recommend Tera Term Pro) and configure the serial port as
Follows:
Baudrate 115200
Data bits 8
Parity none
Stop bits 1
Handshake XON / XOFF
For latest documentation, BSPs, etc. please visit:
!
tq-group.com/en/products/tq-embedded/arm-architecture/ STKaRZG2x
© TQ-Systems GmbH 2021 | All data is for information purposes only | Subject to change without notice | EMB_QSG_STKaRZG2x_Rev002
B
B
SUPPLY THE STKaRZG2x WITH POWER
Double-check the mains voltage required for the included
Power supply, then connect it to connector X5 on the
STKaRZG2x.
Caution when using a different power supply! The Starterkit
can be operated using a regulated supply voltage of 16...26V
(nom. 24V)!
ESTABLISH SERIAL CONNECTION
The boot messages of boot loader and operating system are
displayed by the terminal emulator.
Support.tq-group.com/TQMaRZG2x
A