Advertisement
ASSEMBLY INSTRUCTIONS - PLEASE READ CAREFULLY
1. Do not remove the PVC masking film until the enclosure is fully assembled. The PVC masking film
will protect the enclosure's outer finish during installation.
2. The concrete base should be 6" thick, 188" long and 104" wide. Please note that the concrete base
should be level, or the "C" (access) panels may be difficult to install.
3. Mark the concrete base for outside the enclosure (93
4. Assemble the "A#-B" (corner) assemblies through the holes provided using Hex Head Screws. (For
best results, insert a bead of silicone caulk into the inside bend of the "A#" panel corners.) Set them on
the marked concrete base (Fig. 1).
Page 1
Model No. 1000TDS-AL (4/5/23)
Enclosure Plan View
www.safe-t-cover.com
" wide by 177
" long).
3
1
/
/
8
8
1-800-245-6333
Version 2.0
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for HYDROCOWL SAFE-T-COVER 1000TDS-AL
Summary of Contents for HYDROCOWL SAFE-T-COVER 1000TDS-AL
- Page 1 Model No. 1000TDS-AL (4/5/23) ASSEMBLY INSTRUCTIONS - PLEASE READ CAREFULLY Enclosure Plan View 1. Do not remove the PVC masking film until the enclosure is fully assembled. The PVC masking film will protect the enclosure’s outer finish during installation. 2. The concrete base should be 6” thick, 188” long and 104” wide. Please note that the concrete base should be level, or the “C”...
- Page 2 FIG. 1 NOTE: model sizes and configurations vary, see the Enclosure Plan View. 5. Position the “A1” and “A2” (end) panels firmly together and then assemble them using Hex Head Screws through the holes provided making sure that the panels are pulled tightly together before tightening the screws.
- Page 3 FIG. 2 NOTE: model sizes and configurations vary, see the Enclosure Plan View. 10. Inspect the alignment of the “C” (access) panels during assembly. Verify that their removal and replacement allow adequate space and positioning with the adjacent panels prior to attaching brackets to the concrete.
- Page 4 13. Complete the bracket and clip installations in the following steps on one side and one end before moving on to the other side and end of the enclosure. Fastening each anchoring bracket will require two (2) Hex Head Screws installed first and then one (1) Anchor per bracket installed last. Fastening each Inside Roof Clip will require one (1) Hex Head Screw per clip.
- Page 5 Model No. 1000TDS-AL CONTENTS 1. Assembly parts included: A. 2- “A1” (end corner) Panels B. 2- “A2” (end corner) Panels C. 4- “B” (corner side) Panels D. 2- “C” (access) Panels E. 2- “C” (access) Panels with Drain Flaps F. 2- “D1” (roof end) Panels G.
Need help?
Do you have a question about the SAFE-T-COVER 1000TDS-AL and is the answer not in the manual?
Questions and answers