Advertisement
Quick Links
ASSEMBLY INSTRUCTIONS
READ CAREFULLY
1. Center a "6" thick concrete base around installed BFP.
A. Place expansion material around riser pipes and place conduit for electrical power
before placing concrete. CONCRETE SHOULD BE FINISHED ABSOLUTELY
LEVEL, FLAT AND SMOOTH. Allow concrete to cure.
B. Mark concrete with outside dimensions of enclosure. (Center around BFP).
Advertisement
Related Manuals for HYDROCOWL Safe-t-Cover 300DS Series
Summary of Contents for HYDROCOWL Safe-t-Cover 300DS Series
- Page 1 ASSEMBLY INSTRUCTIONS READ CAREFULLY 1. Center a "6" thick concrete base around installed BFP. A. Place expansion material around riser pipes and place conduit for electrical power before placing concrete. CONCRETE SHOULD BE FINISHED ABSOLUTELY LEVEL, FLAT AND SMOOTH. Allow concrete to cure. B.
- Page 2 2. Using four (4) hexhead screws for each section, assemble both "A-B" sections thru holes provided and set on marked concrete base (FIG 2). 3. Set "D" (roof) panel on "A-B" sections and using four (4) hexhead screws fasten thru holes provided.
- Page 3 Immediately remove masking film after installation. If these panels get wet when the film is still on, water will irreversibly stain the panels. Summertime heat will bake the film on the panels. Contents Model No. 300-DS Series Model No. 300TDS Series Contents 2- "A"...
Need help?
Do you have a question about the Safe-t-Cover 300DS Series and is the answer not in the manual?
Questions and answers