Craftsman 12AVP2R3391 Operator's Manual page 24

PREMIUM DRIVE (IF EQUIPPED)
The drive system consists of pulleys, a belt , and a cable
linking the transmission to the drive handle. As these
components wear, adjustment may be needed. To adjust
the drive linkage perform the following:
1. Rotate the drive cable fitting located on the left upper
handle upward (Figure 39).
2
1
Figure 39
2. Pull the fitting away from the handle.
3. Unhook the cable (a) and remove the metal bushing (b)
from the plastic drive handle (Figure 40).
Figure 40
4. Replace bushing in the lower hole and reattach the
cable through the bushing and lower hole in the
handle (Figure 41).
Figure 41
5. Reinsert the drive cable fitting into the upper handle
and rotate it downward.
6. Start the mower and check the function of the drive
handle.
SERVICE AND MAINTENANCE
b
a
Replacing Battery (If Equipped)
Batteries contain sulfuric acid which may cause
burns. Do not short circuit or damage batteries in
any way. Do not put batteries in fire as these may
burst or release toxic materials.
1. Removing the battery
a. Open the charging port cover (a) and remove the
battery box cover (b).
b. Disconnect the positive and negative leads from the
battery (c).
c. Lifting up, remove the battery from the battery box.
a
2. Installing the
battery (Figure 43):
a. Insert the battery (c) into the battery box.
b. Connect the positive lead (red) to the positive (+)
terminal (d).
c. Connect the negative lead (black) to the negative
(-) terminal (e).
3. Install the battery box cover and close the charging
port cover.
24
WARNING
:
(Figure 42)
b
c
Figure 42
d
c
(+)
(-)
Figure 43
e