Cutting Height Adjustments; Single Lever - Craftsman 12AVP2R3391 Operator's Manual

Installing
Battery Pack
1
Removing
1
Battery Pack
2
Figure 21

Cutting Height Adjustments

This mower is equipped with one of three types of cutting
height adjustment. Refer to Single Lever, Dual Lever or
Rear Wheel/Caster Wheels in this section.

SINGLE LEVER

The single lever cutting height adjustment is located
above the rear left wheel (Figure 22).
1. Carefully pull the height adjustment lever outward
towards wheel (mower will tend to fall when lever is
moved outward).
2. Move lever to desired position for a change in cutting
height.
3. Release lever towards deck.
ADJUSTMENTS
3
2
4
3
DUAL LEVER
Front Wheel Drive Mowers -
adjustment levers are located above the front and rear
right wheels.
Rear Wheel Drive Mowers -
adjustment levers are located above the front and rear
left wheels.
NOTE: Front wheel drive mower shown in Figure 23.
NOTE: On select mowers - The front and rear height
adjustment levers move in the opposite direction to adjust
height.
1. Carefully pull the height adjustment lever outward
towards wheel (mower will tend to fall when lever is
moved outward).
2. Move lever to desired position for a change in cutting
height.
3. Release lever towards deck.
IMPORTANT: All wheels must be placed in the same
position. For rough or uneven lawns, move each height
adjustment lever to a higher position. This will prevent
you from cutting the grass too close to the ground.
12
2
Lower
Higher
3
Figure 22
The dual lever cutting height
The dual lever cutting height
1