Usb One Touch Copy Button; Leds - QNAP TS-364 User Manual

USB One Touch Copy Button

The USB One Touch Copy button allows you to copy data backups from a USB device to the NAS or from the
NAS to a USB device.
This feature supports incremental backups. The NAS only copies files that were modified or added after the
last backup.
To configure the behavior of the button when an external device is connected to the button's USB port,
install and use Hybrid Backup Sync on your QNAP operating system. For details, see the
documentation.

LEDs

LEDs indicate the system status and related information when the device is powered on. The following
LED information applies only when the drive is correctly installed and when the device is connected to the
network or to a host.
For details on the location of the LEDs, see
LED
M.2 SSD Flashes red
Red
Flashes green
Green
Off
Multi-Gigabit Green
speed
Orange
Off
Multi-Gigabit Orange
activity
Flashes orange
Off
USB One Touch Flashes blue every 0.5
Copy seconds
Blue
Off
Front Panel.
Status
The data is being accessed and a read/write error occurs
during the process.
A drive read/write error occurred.
Data is being accessed.
The drive is ready.
No drive was detected.
The network connection is operating at 2.5 Gbps.
• The network connection is operating at 1 Gbps.
• The network connection is operating at 100 Mbps.
The network connection is operating at 10 Mbps.
A network connection has been established.
The device is being accessed on this network.
There is no network connection.
• A USB device connected to the USB One Touch Copy
• A USB device connected to the front USB port is being
• A USB device connected to the front USB port is being
A USB device is detected in the front USB port.
No USB device is detected.
Description
port is detected.
removed from the device.
accessed.
TS-364 User Guide
Hybrid Backup Sync
Basic Operations 44