Table of Contents
Advertisement
4. Basic Operations
This chapter describes basic NAS operations.
Power Button
Operation
Power on
Power off
Force power off
Reset Button
Operation
Basic system reset
Advanced system
reset
User Action
Press the button once.
Press and hold the button for 1.5
seconds.
Press and hold the button for 5 seconds. The device powers off.
User Action
Press and hold the
button for 3 seconds.
Press and hold the
button for 15 seconds.
The device powers on.
The device powers off.
The following settings are reset to default:
• System administrator password: The default password
is the first MAC address in uppercase letters
without special characters. For example, if the first
MAC address is 00-08-9B-F6-15-75, then the admin
password would be 00089BF61575.
Tip
You can find the first MAC address with
Qfinder Pro or attached to a label on the
device listed as MAC1.
• The admin account is automatically enabled
• TCP/IP configuration:
• Obtain IP address settings automatically via DHCP
• Disable jumbo frames
• If port trunking is enabled (multi-LAN models
only), the port trunking mode is reset to "Active
Backup (Failover)".
• System port: 8080 (system service port)
• Security level: Low (Allow all connections)
• LCD panel password: (blank)
• VLAN: Disabled
The default factory settings are restored.
To retrieve old data after an advanced system reset,
recreate the previous folder structure on the NAS.
TS-364 User Guide
Result
Important
Use this method only when
the device is unresponsive.
Result
Basic Operations
43
Advertisement
Table of Contents
