Table of Contents
Advertisement
Adjusting the telephone settings
Testing DECT encryption
When this function is enabled, the handset tests whether the DECT connection to the base is
secure, i.e. is encrypted. If not, a message is shown on the display.
Settings
Change (
= enabled)
If a repeater without encryption is used, the secure connection test must be disabled.
If, on the base, encryption is disabled at a later time whilst the secure connection test is enabled
(because a repeater needs to be connected for example), Security Info - Press INFO is shown on
the handset.
Info . . . the situation is explained
During a call
A sound and a message on the display indicate when encryption is disabled on the base during
a call.
Continue call:
Stop call:
If neither is pressed, the call is stopped automatically after a certain time.
Testing the secure connection status during a call:
Press the Hash key
display
Changing the handset PIN
The handset is protected against unauthorised use by a PIN. The handset PIN must be entered
e. g. when switching off the keypad lock.
Change the handset's 4-digit PIN (default setting: 0000):
Settings
the current PIN
If the correct handset PIN is not entered after 5 failed attempts, a 15-second timer is
started. Every failed attempt thereafter doubles the timer (up to a maximum delay of
8 hours between PIN entry attempts).
54
OK
System
Sec. off . . . the secure connection test is disabled
Yes
No
for a longer time . . . the secure connection status is shown on the
OK
System
OK
enter the new handset PIN
OK
Security Check
OK
Handset PIN
OK
OK
enter
Advertisement
Table of Contents
