Gigaset SL800 H PRO Instruction Manual page 42

Bluetooth
Making a device visible/invisible
When Bluetooth is enabled, the handset is visible to Bluetooth devices in range for 5 minutes. It
is then invisible after this time.
Making a device visible again:
Settings
Change ( = enabled)
The icon in the status bar flashes whilst the handset is visible.
Even when the handset is invisible, requests from devices known as trustworthy are
accepted.
Registering Bluetooth devices
The distance between the handset in Bluetooth mode and the active Bluetooth device (headset
or data device) should not exceed 10 m.
Only one headset / hearing device can be registered. When more than one headset is
found, enable the one required using the checkbox (
Settings
search starts (may take up to 30 seconds) . . . the names of found devices are displayed . . .
possible options:
Register device:
Showing information:
Repeat search:
Cancel search:
Editing the list of known (trusted) devices
Open the list
Settings
known devices are listed, an icon indicates the type of device
Bluetooth headset
Bluetooth data device
If a device is connected, the relevant icon is shown in the display header instead of
42
OK Bluetooth
OK Bluetooth
Options Trust Device
The subsequent process is dependent on the device to which the
connection is being made. Normally, both devices show the same
authentication code.
Confirm the authentication code on both devices . . . The devices
are connected. The device is included in the list of known devices.
Select the device as required
address are displayed, as well as functions possible for this device
Options Repeat Search
Cancel
OK Bluetooth
OK Visibility
= enabled).
OK Search Devices
OK
View . . . The device name and
OK
OK Known Devices
OK . . . the
OK . . . the
.