Using The Remote 2 Terminal - Panasonic PT-D7000E Operating Instructions Manual

Using the REMOTE 2 terminal

Using the REMOTE 2 terminal provided on the side of the main unit, it is possible to operate the projector from a
control panel etc. furnished in a distant location where infrared remote control signal cannot be received.
Example of a control panel layout
Projector set up in a meeting room
Pin assignments and control
Be sure to short-circuit Pins
D-Sub 9-pin (female)
external appearance
Note
• The "POWER", "RGB" and "VIDEO" buttons on the remote control and projector will not operate when
pins
those functions, remote control buttons and RS-232C commands.
76
and when controlling.
and are shorted. In addition, it disables the main unit operation sections that correspond to
Remote terminal
Remote terminal/External control
STANDBY
RGB1
RGB2
Control panel located in a different room
Open (H)
Names of terminals
1 GND
2 POWER OFF
3 RGB1 Other
4 RGB2 Other
5 VIDEO Other
6 S-VIDEO
Other
7 AUX Other
8 SHUTTER OFF
9 RST / SET
Controlled by remote control
External control
ON
LAMP
VIDEO
S-VIDEO
Short (L)
GND
ON
RGB1
RGB2
VIDEO
S-VIDEO
AUX
ON
Controlled by external contact