Table of Contents
Advertisement
Installation Setting
A projection scheme can be chosen depending on the installation of the projector. If the picture is shown upside
down or in reverse, change the projection scheme using the following figures A to D.
A: Floor mount front projection (Front – Floor mount)
C: Floor mount rear projection (Rear – Floor mount)
Select the setting by displaying the on-screen indications using buttons of the remote control or the control panel on
the main unit.
Procedure of setting
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
LANGUAGE
OPTION
TEST PATTERN
SIGNAL LIST
SECURITY
:MENU SELECT
ENTER:SUB MENU
OPTION
PROJECTOR ID
SETTING
LAMP SELECT
LAMP POWER
RS232C SETTING
OSD POSITION
SYSTEM INFORMATION
COLOR MATCHING
VIDEO SETTING
AUTO SETUP
:MENU SELECT
:CHANGE
2
FRONT-F
DUAL
HIGH
2
OFF
B: Ceiling mount front projection (Front – Ceiling mount)
D: Ceiling mount rear projection (Rear – Ceiling mount)
Press the "MENU" button.
The MAIN MENU screen will be displayed.
Select "OPTION" with the
buttons.
Press the "ENTER" button.
The OPTION screen will be displayed.
Select "SETTING" with the
buttons and choose a projection
scheme with the
Each time
or
button is pressed, the types of
projection scheme, together with its indications, are
toggled through a cycle as follows:
FRONT-F
REAR-C
Press the "MENU" button twice.
The on-screen indications disappear and the
normal screen appears again.
buttons.
FRONT-C
REAR-F
65
Advertisement
Table of Contents
