Vivotek FD8167A User Manual page 164

VIVOTEK
s<0~(m-1)>_h 20000~"capability_videoin_c<n>_h2
264_bitrate 64_maxbitrate"
s<0~(m-1)>_h framerate,imagequality
264_prioritypoli
cy
s<0~(m-1)>_h 1~"capability_videoin_c<n>_h264_m
264_maxframe axframerate"
s<0~(m-1)>_h 0~2
264_profile
s<0~(m-1)>_h <boolean>
265_dintraperio
d_enable
s<0~(m-1)>_h 250, 500, 1000, 2000, 3000, 4000
265_intraperiod
s<0~(m-1)>_h cbr, vbr
265_ratecontrol
mode
164 - User's Manual
cbr and "quant"= 100.
* Only available when
"capability_smartstream_version"=2.
0
4/4 The target bit rate in constant bit rate
mode.
*
Only valid when "ratecontrolmode"=
cbr
4/4 Set prioritypolicy
*
Only valid when "ratecontrolmode"=
cbr
1/4 The maximum frame rates of a H264
stream at different
resolutions("capability_videoin_c0_re
solution ") are recorded in
"capability_videoin_c<n>_h264_maxf
ramerate"
1/4 Indicate H264 profiles
0: baseline
1: main profile
2: high profile
4/4 Enable "Dynamic intra frame period".
* Only available when
"capability_videoin_c<0~(n-1)>_dint
raperiod_support" is 1 and h265 is
listed in "capability_videoin_codec".
* We support this parameter when the
version number (httpversion) is equal
or greater than 0301c.
4/4 The time interval between two
I-frames (Intra coded picture).
The unit is millisecond (ms).
* Only available when h265 is listed in
"capability_videoin_codec".
4/4 cbr: Constant bit rate mode.
vbr: Fixed quality mode, all frames are
encoded in the same quality.