Table of Contents
Advertisement
6 Changing the bulb
You must not attempt to change the bulb immediately after the microscope has been
used, as the bulb will still be hot and so there is a risk that the user could be burnt.
Before changing the bulb the device must be switched off and unplugged.
To change the bulb the cover of the lamp housing [b] needs to be removed. Therefore
you previously have to loosen the appropriate fastening screw [a]. Now the defective
bulb can be pulled out of the socket and be replaced with a new one [c]. We
recommend that here you should also test again, to check that heat is no longer being
produced. After the cover has been reattached and fixated, the bulb replacement
procedure is complete.
Important:
When fitting the new bulb into the socket, it must only be handled with sterile gloves or
using the bulb packaging film. Grease and dust residue can have a negative effect on
the light quality and service life.
OCM-1-BA-e-2211
20
Advertisement
Table of Contents
