JVC HR-J880EK Instructions Manual page 20

Table of Contents

Advertisement

20
EN
Variable Speed Search
During playback, turn the JOG dial to the right for
forward variable-speed search, or to the left for reverse
variable-speed search.
OR
During playback, press
w
● The more times you press, the faster the playback picture
moves.
● To decrease speed, press the button for the opposite direction.
To resume normal playback, press
Skip Search
During playback, press 30 SEC 1 to 4 times to skip over
unwanted sections.
Each press initiates a 30-second period of fast-motion
playback. Normal playback resumes automatically.
To resume normal playback during a Skip Search,
press
.
4
or
.
e
.
4
Index Search
Your recorder automatically marks
index codes at the beginning of
each recording. Additional index
codes can be added manually
during playback. (See below.) This
function gives you quick access to
any one of 9 index codes in either
direction.
NOTE:
Before starting, make sure the recorder is in the Stop mode.
Activate Index Search.
Press
or
(
or
w
e
2
6
displayed on the TV screen and search begins in the
corresponding direction.
● To access index codes 2 through 9, press
until the correct index number is displayed.
Example:
To locate the beginning of B from the current position, press
twice.
To locate the beginning of D from the current position, press
once.
Current position
● When the specified index code is located, playback begins
automatically.
Manual Index Mark/Erase
To mark an index code ...
... during playback press INDEX MARK on the recorder.
● The recorder will mark an index code at that location.
● If "O.S.D." is set to "ON" (
screen while an index code is being marked.
To erase an index code ...
... during playback or still press INDEX ERASE on the recorder.
● The recorder will fast-forward to the nearest index code and
erase it. Playback continues after the index code is erased.
● If "O.S.D." is set to "ON" (
screen while an index code is being erased.
NOTES:
● Video Navigation (
pg. 38) may not work properly when an
index code (VISS signal) is marked or erased manually near a
start point of recorded programme.
● During timer-recording you cannot mark an index code
manually.
PLAYBACK (cont.)
). "
1" or "
1" is
2
6
w
or
e
repeatedly
Index number
pg. 61), "MARK" blinks on the
pg. 61), "ERASE" blinks on the
w
e

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hr-j880eu

Table of Contents