Table of Contents
Advertisement
48
EN
Synchro Editing
Recorder
Camcorder
To LANC connector
Player
SYNCHRO EDIT
connector
LANC cable
(not provided)
The Synchro Editing function synchronizes the start of the
playback and recording operations when starting an edit
operation using a camcorder with LANC connector and your
recorder.
A
Make connections.
Connect your recorder to camcorder (
connect your recorder's SYNCHRO EDIT connector to
the camcorder's LANC connector.
B
Set the recorder's input mode.
Press AUX (number key "0") and/or PR to select "F-1".
C
Set the edit mode.
See "PICTURE CONTROL" on page 61.
D
Locate the start point.
Start playback of the tape in the camcorder, and pause
playback when you find the point where you want to start
editing. Press and hold 9 and press 7 on your recorder
so that the recorder enters the Record-Pause mode.
E
Start Synchro Editing.
Press SYNCHRO 7/79.
F
Pause Synchro Editing.
Press SYNCHRO 7/79 again.
● Repeat steps 4 – 6 as necessary.
NOTES:
● The Synchro Editing function may not work with the initial part
of a camcorder tape.
● The Synchro Editing function cannot be used when using the
JLIP function. (Pressing SYNCHRO 7 / 79 cancels the JLIP
function.)
● The Synchro Editing function may not work properly with
some type of camcorder.
● When you select "EDIT" to dub tapes in step 3, be sure to
select "AUTO" (or "NORM" when "B.E.S.T." is set to "OFF")
after you finish dubbing the tapes.
EDITING (cont.)
pg. 47), and
Advertisement
Table of Contents
