Table of Contents
Advertisement
4. Empty the drain pump. Refer to the emergency
drain procedure.
5. When the drain pump is empty, install the inlet
hose again.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
ALARM CODES AND POSSIBLE FAILURES
The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to
the tables).
WARNING! Deactivate the appliance before carrying out any check.
With some problems, the display shows an alarm code and the Start/
Pause
button may flash continuously:
If the appliance is overloaded, remove some items from the drum
and/or keep pressed the door while touching the Start/Pause but-
ton until the indicator
Problem
The appliance does not
fill with water properly.
stops flashing (see the picture below).
Possible solution
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low. For this
information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the inlet hose has no kinks, damages or bends.
•
Make sure that the connection of the water inlet hose is correct.
•
Make sure that the filter of the inlet hose and the filter of the valve are
not clogged. Refer to 'Care and cleaning'.
WARNING! Make sure that the
temperature is higher than 0 °C before
you use the appliance again.
The manufacturer is not responsible
for damages caused by low
temperatures.
35
Advertisement
Table of Contents
