Table of Contents
Advertisement
By means of this button, you can change the
default spin speed or set one of the
additional spin options:
•
Rinse Hold
. The related indicator comes
on.
The final spin is not performed. The water of the
last rinse is not drained out to prevent the
fabrics from creasing. The washing programme
ends with water in the drum.
The door stays locked and the drum turns
regularly to reduce creasing. You must drain the
water to unlock the door.
If you touch the Start/Pause
appliance performs the spinning phase and
drains the water.
•
No spin
. The related indicator comes on.
Set this option to deactivate all spin phases. The
appliance performs only the draining phase of
the selected washing programme. Set this
option for very delicate fabrics. The rinse phase
uses more water for some washing programmes
•
Night . The related indicator comes on.
The intermediate and the final spinning phases
are suppressed and the programme ends with
water in the drum. This helps to reduce
creasing. The door stays locked. The drum turns
regularly to reduce creasing. You must drain the
water to unlock the door.
As the programme is very quiet, it is suitable for
use at night time when cheaper electricity tariffs
are available. In some programmes the rinses
are performed with more water.
If you touch the Start/Pause
appliance performs only the draining phase.
The appliance empties the water out
automatically after approximately 18
hours.
PREWASH
With this option you can add a prewash phase to a
washing programme.
The corresponding indicator above the touch
button illuminates.
•
Use this option to add a pre-wash phase at 30
°C before the washing phase.
This option is recommended for heavily soiled
laundry, especially if containing sand, dust, mud
and other solid particles.
The options can increase the
programme duration.
PERMANENT EXTRA RINSE
With this option you can add a few rinses
according to the selected washing programme.
Use this option for people with allergies to
detergent residues and with sensitive skin.
The corresponding indicator above the touch
button illuminates and also stays permanently on
during next cycles until this option is deactivated.
button, the
STAINS
Touch this button to add the stain phase to a
programme.
The corresponding indicator above the touch
button illuminates.
Use this option for laundry with hard stains to
remove.
When you set this option, put the stain remover into
compartment
CHILD LOCK
With this option you can prevent children from
playing with the control panel.
button, the
To activate/deactivate this option, hold the Plus
Steam button pressed until the indicator
comes on/goes off on the display.
When it is activated, the appliance will default to
this option after you switch it off or change/reset
the programme. If you press any button, the
indicator
disabled.
The Child Lock function may not be available for a
few seconds after switching the appliance on.
DELAY START
With this option you can delay the start of a
programme to a more convenient time.
Touch the button repeatedly to set the required
delay. The time increases in steps of 1 hour up to
20 hours.
The display shows the indicator
selected delay time. After touching the Start/Pause
This option increases the programme
duration.
.
This option increases the programme
duration.
This option is not available with a
temperature lower than 40 °C.
blinks to indicate that the buttons are
and the
19
Advertisement
Table of Contents
