Emergency Door Opening - Zanussi ZW84PCBI User Manual

Table of Contents

Advertisement

Problem
You cannot open the
appliance door.
The appliance makes an
unusual noise and vi-
brates.
The programme dura-
tion increases or de-
creases during pro-
gramme execution.
The washing results are
not satisfactory.
Too much foam in the
drum during the wash-
ing cycle.
After the washing cycle,
there are some deter-
gent residues in the dis-
penser drawer.
After the check, activate the appliance. The programme continues from the point
of interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre are on the rating plate.

EMERGENCY DOOR OPENING

In case of power failure or functioning failure the
appliance door remains locked. The washing
programme continues when the power is restored.
If the door remains locked in case of failure, it is
possible to open it using the emergency unlock
function.
Before opening the door:
Make sure that a washing programme that ends with water in tub, has
not been selected.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the drum.
Make sure that the appliance receives electrical power.
This problem may be caused by a failure of the appliance. Contact the
Authorised Service Centre.
If you need to open the door, please read carefully "Emergency door
opening".
Make sure the levelling of the appliance is correct. Refer to "Installa-
tion instruction".
Make sure that the packaging and/or the transit bolts are removed.
Refer to "Installation instruction".
Add more laundry in the drum. The load may be too small.
The AutoAjust System is able to adjust the programme duration ac-
cording to the type and the laundry load size. Refer to "The AutoAjust
System load detection" in "Daily Use" chapter.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before you wash
the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Reduce the quantity of detergent.
Make sure that the flap is in the correct position (UP for powder deter-
gent - DOWN for liquid detergent).
Make sure you have used the detergent dispenser according the indi-
cations given in this user manual.
Possible solution
CAUTION! Risk of burns! Make
sure that the water temperature is
not too high and the laundry is
not hot. If necessary, wait until
they cool down.
CAUTION! Risk of injury! Make
sure that the drum is not rotating.
If necessary, wait until the drum
stops rotating.
37

Advertisement

Table of Contents
loading

Table of Contents