Table of Contents
Advertisement
9. INSTALL THE ADAPTER AND THE TRANSITION (IF NEED BE)
(INTERNAL BLOWER(S) HOOD ONLY)
Using standard 3/8" screws provided, secure the
adapter to the top (or back) of the hood (2 screws
for a 3¼" x 10" adapter/damper and 4 screws for
a 4½" x 18½" adapter). Seal the adapter to the
hood using metal foil duct tape. For round ducting,
install an appropriate sized transition and seal
the joints with metal foil duct tape.
10. INSTALL WOOD MOUNTING STRIP
Measure and mark a level line on wall above cooktop location for the wood
mounting strip (see illustration at right and under step 2). Remove wood mounting
strip from back of hood.Use no. 10 - 2" flat head screws to secure the mounting
strip to the drywall. Make sure to hit the wall studs.
Due to the weight of this hood, ensure that the wood strip is
attached to all of the available studs (2 studs minimum for a
30" width hood, more as hood width increases); not into the
drywall alone.
11. INSTALL ANKE60 RECIRCULATION KIT
Refer to the instructions sheet included with the recirculation kit for details.
12. INSTALL AEE OPTIONAL DECORATIVE FLUE COVER
Assemble both sides to the front using 4 no. 8 x 0.375" included.
Place the decorative flue cover on top on the range hood.
Secure the decorative flue cover to the top of the range hood using 6 no. 8 x 0.375" included.
1
x 4
HR0069A
HJ0013
CAUTION
1. Drywall
2. Wood mounting strip
3. Flat head screw
(NON-DUCTED INSTALLATION ONLY)
2
10
HD0263A
4. Wall anchor location
5. Back of hood outline
6. Wall studs
(DUCTED INSTALLATION ONLY)
3
x 6
Advertisement
Table of Contents
