Table of Contents
Advertisement
Always follow the instructions that you
find on the packaging of the detergent
products, but we recommend that you
do not exceed the maximum indicated
level. This quantity will however
guarantee the best washing results.
After a washing cycle, if necessary,
remove any detergent residue from the
detergent dispenser.
POSITION OF THE DETERGENT FLAP
1. Pull out the detergent dispenser until it stops.
2. Remove the drawer. Press the place with the
(PUSH) to remove the drawer easily.
3. To use liquid detergent, adjust the flap in right
position, turn the flap down.
With the flap in the position DOWN:
•
Do not use gelatinous or thick liquid
detergents.
•
Do not exceed to liquid detergent dose
indicated on the flap.
•
Do not set the prewash phase.
•
Do not set the delay start function.
4. Measure out the detergent and the fabric
conditioner.
5. Put back the drawer in the recess.
Make sure that the flap does not cause a blockage
when you close the drawer.
1
SETTING A PROGRAMME
1. Turn the programme dial to select the desired
washing programme.
The indicator of the Inicio/Pausa
flashes.
The display shows an indicative programme
duration.
2. To change the temperature and/or the spin
speed, touch the related buttons.
3. If desired, set one or more options by touching
the related buttons. The related indicators
illuminate on the display and the given
information changes accordingly.
If a selection is not possible an
acoustic signal sounds.
STARTING A PROGRAMME
Touch the Inicio/Pausa
programme. It is not possible to start the
programme when the indicator of the button is off
and doesn't flash (e.g. programme dial on a wrong
2
position).
The related indicator stops flashing and stays on.
The programme starts, the door is locked. The
display shows the indicator
The drain pump can operate shortly
before the appliance fills water.
STARTING A PROGRAMME WITH THE
DELAY START
1. Touch the Inicio Diferido button repeatedly until
the display shows the desired delay time. On
the display the indicator shows
2. Touch the Inicio/Pausa
appliance door locks and starts the countdown
of the delay start. The display shows the
indicator
When the countdown is completed, the programme
starts automatically.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Inicio/Pausa
appliance. The related indicator flashes.
2. Touch the Inicio Diferido button repeatedly until
the display shows
off.
3. Touch the Inicio/Pausa
start the programme immediately.
button
button to start the
.
.
button. The
.
button to pause the
and the indicator
button again to
goes
19
Advertisement
Table of Contents
