Using The Handset (Remote Operation); Voice Menu - Panasonic KX-TG2343W Operating Instructions Manual

Using the Handset (Remote Operation)

If "New message" is displayed on the handset, new messages have been
recorded.
• If the Message Alert is turned on (p. 22), the Ringer/Message Alert indicator on
the handset will flash slowly when new messages have been recorded and the
handset is not in use.
To play back messages
Press [MENU].
1
Press Select at "Message play".
2
• The unit announces the number of new messages
and only new messages are played back from the
speaker. To switch to the receiver, press [C]. To
switch back to the speaker, press [s].
• When you have no new messages, the unit
announces "No new messages. All message playback"
and plays back all messages.
• When you have no messages, the unit announces
"No messages".
• To play all messages, press [5].
• If you do not press any button, the voice menu will
start (see below).
To end remote operation, press [OFF].
3
• If a call is received during playback, the unit rings and playback stops. To answer
the call, press [C] or [s]. For playback, start again from the beginning after
hanging up.
• At the end of the last message, "End of final message" is heard. The unit will
announce the remaining recording time if it is less than 3 minutes.
• If you hear "Memory full" after playback, erase unnecessary messages (p. 47).

Voice menu

If you do not press any buttons at the end of the last message, the unit will
announce "End of final message" and the voice menu will begin.
The unit announces, "Press 4 to play back new messages. Press 5 to play back all
messages."
• You can press buttons for other playback options (p. 46) even if the voice menu
has started.
• If you do not press any button within 10 seconds after the voice menu, the
handset will exit remote operation.
For assistance, please call: 1-800-211-PANA(7262)
Listening to Messages
Message play
Back
K
MENU=Call back
4 =Erase msg
@
Repeat
K
Handset
Select
L
dB
Skip
L
45