Key Tone; Re-Registering The Handset - Panasonic KX-TG2312 Operating Instructions Manual

Special Features

Key Tone

You can select whether or not the handset keys will sound tones (key tone,
confirmation tone, error tone). The factory preset is ON.
Press [MENU].
1
Scroll to "Initial setting" by pressing [d]
2
or [B], then press Select.
Scroll to "Key tone" by pressing [d] or [B],
3
then press Select.
Select "Off" or "On" by pressing [d] or [B].
4
Press Save, then press [OFF].
5

Re-registering the Handset

If "No link to base. Move closer to base, try again." is displayed
even when using the handset near the base unit, the handset may have lost
communication with the base unit. You need to re-register the handset to the base
unit.
• Have both the handset and base unit nearby during registration.
• Follow steps 1 and 2 listed below. You have about 1 minute to complete
them.
Base unit:
1
Press and hold [HANDSET LOCATOR] until
the CHARGE indicator flashes.
Handset:
2
Press and hold [FLASH/CALL WAIT] until
"Handset Registering" is displayed.
• When registration is complete, a beep sounds
from the handset.
• Wait for 20 seconds after registration is
complete while the handset establishes
communication with the base unit.
• If the handset beeps 3 times and "Error!!" is displayed, an error occurred. Try
again from step 1.
• You can stop registration by pressing [OFF] on the handset, and pressing
[HANDSET LOCATOR] on the base unit.
38
Handset
Initial setting
Back
K
Key tone
Back
K
Key tone
:On
Back
K
Handset & Base Unit
Handset
Registering
Handset [1]
Registered
Select
L
dB
Select
L
dB
Save
L
dB