Troubleshooting - Panasonic KX-TG2248S Operating Instructions Manual

2.4ghz digital cordless answering system
Hide thumbs Also See for KX-TG2248S:
Table of Contents

Advertisement

Troubleshooting

Cordless Telephone
Problem
"No link to base.
Place on cradle and
try again." is displayed
and an alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from other
electrical units.
The handset does not ring.
The handset display is blank.
You cannot program function
items.
While programming or
searching, the unit starts to
ring and stops the program/
search.
You cannot make a call with
the handset.
You cannot redial.
The unit does not display the
caller's name and/or phone
number.
For assistance, please call: 1-800-211-PANA(7262)
Cause & Remedy
• You are too far from the base unit. Walk closer
and try again.
• Place the handset on the base unit and try
again.
• Plug in the AC adaptor.
• Raise the base unit antenna.
• Move the handset and the base unit away
from other electrical appliances (p. 3).
• Walk closer to the base unit.
• Raise the base unit antenna.
• Select a clearer channel (p. 23, 36).
• The ringer volume is set to OFF. Set to HIGH,
MEDIUM or LOW (p. 17).
• Charge the battery fully (p. 8).
• Programming is not possible while the unit is
being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
• A call is coming in. To answer the call, press
[
] or [
]. Start again from the beginning
after hanging up.
• Your handset is in remote operation mode
(p. 41). Exit by pressing [OFF].
• If the last number dialed was more than
32 digits long, the number will not be redialed
correctly.
• You need to subscribe to a Caller ID service.
• Other telephone equipment may be interfering
with your phone. Disconnect it and try again.
• Other electrical appliances connected to the
same outlet may be interfering with Caller ID.
• Telephone line noise may be affecting Caller
ID.
• The caller requested not to send his/her
Caller ID information (p. 25).
• If a Caller ID box is connected between the
unit and the telephone wall jack, disconnect
the Caller ID box or plug the unit directly into
the wall jack.
51

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents