Table of Contents
Advertisement
5-3. Imaging Problems (for analog only)
Problem
1. Display position is incorrect.
2. Vertical bars appear on the screen or
a part of the image is flickering.
3. Whole screen is flickering or blurring.
5-4. Imaging Problems (for digital only)
Problem
1. (During DisplayPort signal input)
Turning the power off/on or exiting
power saving mode will move the
windows and icons. In a multi-
monitor environment, switching off
the power of one monitor will switch
the screen settings to a single-
monitor display.
Possible cause and remedy
• Use "Menu Position" in the Setting menu to correct the image
position (see
"Hor. Position" (page
• If the problem persists, use the graphics board's utility if
available to change the display position.
• Use "Clock" in the Setting menu to adjust it (see
20)).
• Use "Phase" in the Setting menu to adjust it (see
20)).
Possible cause and remedy
• In the following step, set the "DP Power Save" function to "Off".
Setting the function to "Off" may increase power consumption.
1.
Press
to turn off the monitor.
2.
Hold down
while pressing
The function will switch between "Off" and "On" each time the
operation is executed.
The current setting status can be identified based on the color
used to display the input port or signal error.
Setting
Input port
On
(default setting)
Off
20)).
"Clock" (page
"Phase" (page
to turn on the monitor.
Signal Error
Chapter 5 Troubleshooting
27
Advertisement
Table of Contents
