Table of Contents
Advertisement
10 Configure the alarm settings [Alarm]
3.
Adjust the "Mic input volume (Camera to PC)" on the [Audio] tab of the "Image/Audio" page as necessary.
(®page 93)
→
The settings and the actual audio detection status are displayed on the bottom of the screen. If the
volume level goes above the audio detection level, a red bar, which indicates that sound has been
detected, is displayed.
If further adjustments are required, repeat from step 2.
Note
•
"Audio detection" can only be used when "Mic input" or "Interactive(Full-duplex)" is selected for "Audio
transmission/reception" on the [Audio] tab of the "Image/Audio" page. (®page 93)
•
Noise or other unwanted sound from the surrounding area may be mistakenly detected.
•
Only the volume of the sound determines whether sound is detected or not, the type of sound does
not matter.
10.7 Configuration of the settings relating to alarm
notification [Notification]
Click the [Notification] tab on the "Alarm" page. (®page 32, page 34)
The settings relating to Panasonic alarm protocol and HTTP alarm notification can be configured in this section.
116
Operating Instructions
Advertisement
Table of Contents
