Reversing The Door Swing - Summit CP35 Instruction Manual

Then rotate the knob counter-clockwise toward MIN. Before the pointer of the
3.
knob reaches MIN, the motor should turn off.

Reversing the Door Swing

This appliance has the capability of the doors opening from either the left or the
right side. The unit is delivered to you with the doors opening from the left side.
Should you desire to reverse the opening direction, follow the directions and
diagram below. The numbers in the diagram indicate the procedure order in the
instructions. If you have a problem, call Customer Service at 1-800-932-4267.
Remove the hinge cap by twisting it off.
1.
Remove the upper hexagonal head screws. The top hinge and the freezer
2.
door can now be removed.
Remove the middle hexagonal head screws. The middle hinge and the
3.
refrigerator door can now be removed.
Remove the cover for middle hinge holes and re-attach it symmetrically to
4.
the holes on the other side.
Tilt the refrigerator back or lay it on its back for steps 6, 7, and 8. Use a pad
5.
or blanket to protect the floor and to avoid scratching the painted finish.
Remove the leveling legs by turning them counterclockwise. Remove the
6.
lower hexagonal head screws, two on the hinge side and one near the front
corner of the other side.
Attach the bottom hinge symmetrically to the other side of the cabinet with
7.
the screws removed in procedure 6. (Do not tighten the screws completely.)
Attach the left side leg and the leg spacer to the other side hole which was
8.
positioned symmetrically.
Remove the upper hinge plastic pins and insert them in the holes from which
9.
the screws were removed in step 2.
Take off the hinge collar caps from both the Freezer and the Refrigerator
10.
doors using a screwdriver and insert them in the hinge collars on the
opposite side.
Attach the shaft to the hinge bottom. Attach the refrigerator door to the shaft.
11.
Rotate the middle hinge 180°. Attach it to the refrigerator door and secure it
12.
with screws. (Do not tighten the screws completely.)
Attach the upper hinge to the freezer door. Attach the freezer door to the
13.
middle hinge and use the screws to attach the upper hinge. (Do not tighten
the screws completely.)
The direction in which the door opens has now been changed; however, the
14.
following points should be checked:
a. The door is on straight.
b. There is no space between the door gasket and the refrigerator unit itself
when the door is closed.
c. The gasket on the hinge side is not caught between the door and the unit
6