Use The Scan Demo App; Change The Scan Demo Symbology Settings - Honeywell ScanPal EDA57 User Manual

Use the Scan Demo App

Use the Scan Demo app to read barcodes or to test your symbology decode
settings.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap the Demos app.
3. Swipe left or right on the screen until Scan Demo appears under the turntable.
4. Point the imager window at the barcode.
5. Press and hold either side Scan button or tap SCAN on the computer screen.
6. Center the aiming beam over the barcode. Make sure the entire barcode is
.
7. Release the Scan button when the computer beeps, and the Good Read LED
Note: In the Scan Demo app, not all barcode symbologies are enabled by default. If a
barcode does not scan, the correct symbology may not be enabled.

Change the Scan Demo Symbology Settings

1. In the Scan Demo app, tap in the upper right corner of the screen.
2. Select Symbology Settings.
3. Modify the symbology parameters.
4. Tap the Back arrow to return to the Scan Demo app.
44
Tap the center of the box image to open the app.
inside of the illumination frame.
briefly turns on. Barcode information appears on the screen.
• Tap the check box next to a symbology name to enable (check mark) or
disable (no check mark) decoding for that symbology.
• Tap the symbology name to view and modify additional configuration
parameters for the symbology selected.
EDA57 User Guide