Use The Scan Demo App; Change The Scan Demo Symbology Settings - Honeywell CN80 Series User Manual

To learn more

Use the Scan Demo App

Use the Scan Demo app to read barcodes, or to test your symbology decode
settings.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Demos.
3. Swipe left or right on the screen until Scan Demo appears under the turntable.
4. Point the scanner window at the barcode.
5. Press and hold any Scan button or tap and hold the on-screen Scan button.
6. Center the aiming beam over the barcode. Make sure the entire barcode is
7. Release the Scan button when the computer beeps, and the Scan Status LED
.
Note: In the Scan Demo app, not all barcode symbologies are enabled by default. If a
barcode does not scan, the correct symbology may not be enabled.

Change the Scan Demo Symbology Settings

1. In the Scan Demo app, tap in the upper right corner of the screen.
2. Select Symbology Settings.
3. Modify the symbology parameters.
4. Tap Back to return to the Scan Demo app.
CN80 Mobile Computer Series User Guide
About Provisioning Mode
Tap the center of the box image to open the app.
inside of the illumination frame.
briefly turns On. Barcode information appears on the screen.
• Tap the check box next to a symbology name to enable (check mark) or
disable (no check mark) decoding for that symbology.
• Tap the symbology name to view and modify additional configuration
parameters for the symbology selected.
see page 91.
55