Before Setting Surface Controls - Frigidaire CGEF3035RF Use & Care Manual

Air circulation in the oven
For best baking results allow 2-4" (5-10 cm) around the
cookware for proper air circulation and be sure pans and
cookware do not touch each other, the oven door, sides or
back of the oven cavity (Fig. 1). Hot air must be able to
circulate around the pans and cookware in the oven for
even heat to reach around the food.
Baking layer cakes with 1 or 2 oven racks
For best results when baking cakes using 2 oven racks,
place cookware on rack positions 2 & 5. For best results
when using a single oven flat rack, place cookware on rack
positions 2, 3 or 4.
About the ceramic glass cooktop
The ceramic cooktop has radiant surface elements located
below the surface of the glass. The design of the ceramic
cooktop outlines the area of the surface element
underneath. Be sure to match the pan size with the
diameter of the element outline on the cooktop and only
flat-bottomed cookware should be used.
The type and size of cookware, the number of surface
elements in use and their settings are all factors that will
affect the amount of heat that will spread to areas beyond
the surface elements. The areas surrounding the elements
may become hot enough to cause burns.
About the radiant surface elements
The element temperature rises gradually and evenly. As the
temperature rises, the element will glow red. To maintain
the selected setting the element will cycle ON and OFF. The
heating element retains enough heat to provide a uniform
and consistent heat during the off cycle.
For efficient cooking, turn OFF the element several minutes
before cooking is complete. This will allow residual heat to
complete the cooking process.
Element on & hot surface indicator lights
Your appliance is equipped with two different types of
radiant surface control indicator lights that will glow on the
backguard — the element on indicator lights and the hot
surface indicator light (See Fig. 2).
The element on indicator lights are located on the control
panel above each radiant element control knob and will
glow when a surface element is turned ON. A quick glance
at this indicator light after cooking is an easy check to be
sure ALL surface controls are turned OFF. The hot surface
indicator light located on the control panel will glow when
any surface cooking area heats up and will remain on until
the glass cooktop has cooled to a MODERATE level.
BEFORE SETTING OVEN CONTROLS

BEFORE SETTING SURFACE CONTROLS

element ON
NOTES
Radiant elements have a limiter that allows the element
to cycle ON and OFF, even at the hi setting. This helps to
prevent damage to the ceramic smoothtop. Cycling at
the hi setting is normal and will occur more often if the
cookware is too small for the radiant element or if the
cookware bottom is not flat.
Be sure to read the detailed instructions for ceramic
glass cooktop cleaning in the Care & Cleaning and
Before You Call checklist sections of this Use & Care
Manual.
Fig. 1
indicator
light
hot
surface
indicator
light
Fig. 2
9