Cookware Material Types - Frigidaire CGEF3035RF Use & Care Manual

BEFORE SETTING SURFACE CONTROLS
Types of cooktop elements
The ceramic glass cooktop has radiant surface elements
located below the surface of the glass. The patterns on the
ceramic glass will outline the size and type of element
available. The single radiant element will have one round
outline pattern shown (keep warm zone is designed to
keep food warm only). The versatile dual radiant element
allows the user to set the smaller inner portion as a single
element or both inner and outer portions may be set to heat
together (See Fig. 1).
Keep warm zone
Single radiant
surface control
surface control
(some models)

Cookware material types

The cookware material determines how evenly and quickly
heat is transferred from the surface element to the pan
bottom. The most popular materials available are:
Aluminum - Excellent heat conductor. Some types of food
will cause it to darken (Anodized aluminum cookware
resists staining & pitting). If aluminum pans slide across the
ceramic cooktop, they may leave metal marks which will
resemble scratches. Remove these marks immediately.
Copper - Excellent heat conductor but discolors easily. May
leave metal marks on ceramic glass (see Aluminum).
Stainless - Slow heat conductor with uneven cooking
results. Is durable, easy to clean and resists staining.
Cast Iron - A slow heat conductor however will retain heat
very well. Cooks evenly once cooking temperature is
reached. Not recommended for use on ceramic cooktops.
Porcelain-enamel on metal - Heating characteristics will
vary depending on base material. Porcelain-enamel coating
must be smooth to avoid scratching ceramic cooktops.
Glass - Slow heat conductor. Not recommended for
ceramic cooktop surfaces because it may scratch the glass.
10
Dual radiant
surface control
(some models)
Fig. 1
Using proper cookware
The size and type of cookware used will influence the
setting needed for best cooking results. Be sure to follow
the recommendations for using proper cookware as
illustrated in Figs. 2 & 3.
Flat bottom and straight
sides.
Tight fitting lids.
Weight of handle does
not tilt pan. Pan is well
balanced.
Pan sizes match the
amount of food to be
prepared and the size of
the surface element.
Made of a material that
conducts heat well.
Easy to clean.
Always match pot
diameter to element size.
Cookware should
have flat bottoms
that make good
contact with the
entire surface
heating element
(See Fig. 2). Check
for flatness by
rotating a ruler
across the bottom
of the cookware
(See Fig. 3).
Curved and warped pan.
Pan larger than cooking area
marked on cooktop by more
than one-half inch or 12mm.
Heavy handle tilts pan.
Pan is smaller or larger
than heating area marked
on cooktop.
Fig. 2
Fig. 3