Advertisement
Product Name:
SKU #:
Thank you for purchasing this LuxenHöme product. This product has been manufactured with the highest
standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged
parts. If any parts are missing or damaged, do not attempt to assemble or use the product.
CARTON CONTENTS:
Description
Top-tier Fountain
Mid-tier Fountain
Fountain Base
Pump
Compatible Pumps for this fountain:
Pump Model No.
JR450/LED
JB450/LED
YH707/LED
YH-LV110T
Tools required for assembly: No tools required for assembly.
Assembly Instructions:
1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. Insert the LED wire from the middle tier into the opening and out through the base of the middle tier.
4. The base of the top tier has the water supply tube attached. Slide this tube through the opening in the top side
of the middle tier so that the water supply tube is coming out of the bottom of the middle tier.
5. Place the top tier on top of the middle tier section, and make sure LED wire is fitted into the small groove
located at the base of the top tier.
6. Turn both sections upside down. The submersible pump has an opening where the water supply tube (affixed
to the bottom of the fountain's middle tier). Slide the water supply tube gently into the pump opening. Connect
the LED connectors (middle tier and base LED lights) into the pump connectors, and twist to tighten. Place
the tiers with the pump inside the fountain base opening (square opening) and draw the pump power cord out
of the fountain back.
7. Add clean water to the fountain to the fountain base. The water level should be approximately 30mm lower
than the edge of the fountain base.
Gray Cement and Resin Modern 2-Tier Basin Outdoor Fountain with LED Lights
WHF825
Quantity
1
1
1
1
Instruction Manual
SAVE THESE INSTRUCTIONS–This manual contains important
safety and operating instructions for power units.
Advertisement
Table of Contents
Related Manuals for LuxenHome WHF825
Summary of Contents for LuxenHome WHF825
- Page 1 Product Name: Gray Cement and Resin Modern 2-Tier Basin Outdoor Fountain with LED Lights SKU #: WHF825 Thank you for purchasing this LuxenHöme product. This product has been manufactured with the highest standards of safety and quality. PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
- Page 2 Gray Cement and Resin Modern 2-Tier Basin Outdoor Fountain with LED Lights SKU #: WHF825 8. Connect the power cable to outlet. If installed properly, water flow in the fountain will begin shortly. 9. Please do not use the electrical plug in wet weather conditions. Please note: On first use, there may be air in the pump.
- Page 3 Product Name: Gray Cement and Resin Modern 2-Tier Basin Outdoor Fountain with LED Lights SKU #: WHF825 MAINTENANCE OF YOUR PUMP: • Keep the water clean – clean water will prolong the useful life of your pump.
- Page 4 Product Name: Gray Cement and Resin Modern 2-Tier Basin Outdoor Fountain with LED Lights SKU #: WHF825 • Check the water level regularly to ensure the pump is completely submerged during operation. The pump should be fully submerged during operation. Do not add water while operating the product. Always disconnect the pump from the power source before adding water.
Need help?
Do you have a question about the WHF825 and is the answer not in the manual?
Questions and answers