Advertisement
Product Name:
SKU #:
Thank you for purchasing this Winsome House product. This product has been manufactured with the highest
standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged
parts. If any parts are missing or damaged, do not attempt to assemble or use the product.
CARTON CONTENTS:
Description
01 Fountain Top
02 Reservoir
03 Pump w/ Adaptor
Tools required for assembly: No tools required for assembly.
Assembly Instructions:
1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. From the opening at the bottom of the fountain base, insert the water supply tube into the pump outlet.
Place the pump upright in the basin and draw the pump power cord out of the fountain back. Connect and
tighten the LED cable to the LED connector on the pump. (①)
4. Make sure the water tube is properly connected with the pump and is not crimped.
5. Add clean water into the basin. The water level should be approximately 30mm lower than the edge of the
basin. (②)
6. Connect the pump power cord to a ground fault circuit interrupter (GFCI) outlet and the product will begin
to function as intended. (③)
7. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.
8. Do not leave your fountain running for extended periods of time when no one is present to observe the
performance.
9. Check the area around your fountain on a regular basis to ensure that there is no leakage.
10. Please refresh the fountain with water each week to ensure it in good condition.
11. Do not add any harmful chemicals to the water as it may alter the paint finish.
Pump Instructions:
Special Warnings and Cautions:
Birds and Pedestal Stone Finish Patio Fountain with LED Lights
WHF878
Accessories standards and type
Contact: sales@winsomehouse.com
Please save this manual for future reference.
Quantity
1
1
1
Instruction Manual
Advertisement
Table of Contents
Related Manuals for LuxenHome WHF878
Summary of Contents for LuxenHome WHF878
- Page 1 Product Name: Birds and Pedestal Stone Finish Patio Fountain with LED Lights SKU #: WHF878 Thank you for purchasing this Winsome House product. This product has been manufactured with the highest standards of safety and quality. PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
- Page 2 Please save this manual for future reference. Product Name: Birds and Pedestal Stone Finish Patio Fountain with LED Lights SKU #: WHF878 Note: The above diagram is for illustrative purposes only. CAUTION: • The pump has been evaluated for use with water only.
- Page 3 Product Name: Birds and Pedestal Stone Finish Patio Fountain with LED Lights SKU #: WHF878 disconnect the pump from the power source before adding water. MAINTENANCE OF YOUR FOUNTAIN: Keep water clean - using clean water will reduce mineral deposits and improve water clarity.
- Page 4 Birds and Pedestal Stone Finish Patio Fountain with LED Lights SKU #: WHF878 3. Regular cleaning of the pump will be necessary depending upon the environment in which it is operated. Clean the pump when it is visibly soiled or when a noticeable drop in performance is detected. Failure to clean the pump will result in overheating of the pump and the voiding of the warranty! 4.
Need help?
Do you have a question about the WHF878 and is the answer not in the manual?
Questions and answers