Advertisement
Product Name:
SKU #:
Thank you for purchasing this Luxen Home product. This product has been manufactured with the highest
standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged
parts. If any parts are missing or damaged, do not attempt to assemble or use the product.
CARTON CONTENTS:
Description
01 Fountain Base
02 Fountain Top
03 Handle
04 Nut
05 Bolt
06 Pump w/ Adaptor
Tools required for assembly: No tools required for assembly.
Assembly Instructions:
1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. Insert handle to fountain top. Insert the bolt through the holes and tighten with nut. (①)
4. Place the fountain on a flat, level surface. From the opening at the top of the fountain base, insert the water
supply tube into the pump outlet at the back of the fountain base. Place the pump upright in the basin and
draw the pump power cord out of the fountain back. (②)
5. Insert hat to handle. (③)
6. Add clean water into the basin. The water level should be approximately 30mm lower than the edge of the
basin. (④)
7. Connect the pump power cord to a ground fault circuit interrupter (GFCI) outlet and the product will begin
to function as intended. (⑤)
8. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.
9. Do not leave your fountain running for extended periods of time when no one is present to observe the
performance.
10. Check the area around your fountain on a regular basis to ensure that there is no leakage.
11. Please refresh the fountain with water each week to ensure it in good condition.
12. Do not add any harmful chemicals to the water as it may alter the paint finish.
Cement/Polyresin Water Wheel and Pump Patio Fountain
WHF851
Accessories standards and type
Contact: sales@winsomehouse.com
Instruction Manual
Please save this manual for future reference.
Quantity
1
1
1
1
1
1
Advertisement
Table of Contents
Related Manuals for LuxenHome WHF851
Summary of Contents for LuxenHome WHF851
- Page 1 Please save this manual for future reference. Product Name: Cement/Polyresin Water Wheel and Pump Patio Fountain SKU #: WHF851 Thank you for purchasing this Luxen Home product. This product has been manufactured with the highest standards of safety and quality. PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
- Page 2 Instruction Manual Please save this manual for future reference. Product Name: Cement/Polyresin Water Wheel and Pump Patio Fountain SKU #: WHF851 Note: The above diagram is for illustrative purposes only. Pump Instructions: Special Warnings and Cautions: CAUTION: • The pump has been evaluated for use with water only.
- Page 3 Please save this manual for future reference. Product Name: Cement/Polyresin Water Wheel and Pump Patio Fountain SKU #: WHF851 Do not let the pump run dry. Pump must be completely submerged for proper operation and cooling. • Do not lift the pump by its power cord.
- Page 4 Cement/Polyresin Water Wheel and Pump Patio Fountain SKU #: WHF851 1. Place the pump in the desired location in your pond or fountain ensuring that it is completely submerged in the water. If the pump is to be used in a pond, raise the pump off of the pond floor to ensure that it is above any dirt that will collect, as this will adversely affect the performance of the pump.
Need help?
Do you have a question about the WHF851 and is the answer not in the manual?
Questions and answers