LuxenHome WHF857 Instruction Manual

Polyresin meditating buddha with pedestal patio fountain with led lights

Advertisement

Product Name:
SKU #:
Thank you for purchasing this Luxen Home product. This product has been manufactured with the highest
standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged
parts. If any parts are missing or damaged, do not attempt to assemble or use the product.

CARTON CONTENTS:

Description
Fountain
Pump
Compatible Pumps for this fountain:
Pump Model No.
JR450/LED
JB450/LED
YH707/LED
YH-LV110T
Tools required for assembly: No tools required for assembly.

Assembly Instructions:

1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. From the opening at the back of the fountain base, insert the water supply tube into the pump outlet. Insert
the LED connector into the pump connector, and twist to tighten. Place the pump upright in the basin and
draw the pump power cord out of the fountain back.
4. Add clean water to the fountain. The water level should be approximately 30mm lower than the edge of the
basin.
5. Connect the power cable to outlet. If installed properly, water flow in the fountain will begin shortly.
6. Please do not use the electrical plug in wet weather conditions. Please note: On first use, there may be air in
the pump. It may take several minutes until all the air escapes.
7. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.
8. Do not leave your fountain running for extended periods of time when no one is present to observe the
Polyresin Meditating Buddha with Pedestal Patio Fountain with LED Lights
WHF857
Quantity
1
1
Contact: sales@winsomehouse.com
Instruction Manual
Please save this manual for future reference.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WHF857 and is the answer not in the manual?

Questions and answers

Summary of Contents for LuxenHome WHF857

  • Page 1 Product Name: Polyresin Meditating Buddha with Pedestal Patio Fountain with LED Lights SKU #: WHF857 Thank you for purchasing this Luxen Home product. This product has been manufactured with the highest standards of safety and quality. PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
  • Page 2 Product Name: Polyresin Meditating Buddha with Pedestal Patio Fountain with LED Lights SKU #: WHF857 performance. 9. Check the area around your fountain on a regular basis to ensure that there is no leakage. 10. Please refresh the fountain with water each week to ensure it in good condition.
  • Page 3 Instruction Manual Please save this manual for future reference. Product Name: Polyresin Meditating Buddha with Pedestal Patio Fountain with LED Lights SKU #: WHF857 Note: The above diagram is for illustrative purposes only. Pump Instructions: Special Warnings and Cautions: CAUTION: The pump has been evaluated for use with water only.
  • Page 4 Please save this manual for future reference. Product Name: Polyresin Meditating Buddha with Pedestal Patio Fountain with LED Lights SKU #: WHF857 • Always disconnect the pump from the power source before performing any maintenance on the pump, lights (if equipped), or fountain.
  • Page 5 Polyresin Meditating Buddha with Pedestal Patio Fountain with LED Lights SKU #: WHF857 3. Connect the power cord from the pump to a properly grounded, grounding type receptacle (GFCI). 4. If necessary, readjust the flow rate to the desired level (remember to always disconnect from the power source before handling the pump).

Table of Contents