MULTIQUIP LT6k Operation Manual page 22

27
24. Radiator Fill Port Plug — Remove this plug to add
coolant to the radiator.
25. Radiator Cap access panel — Remove this panel to
gain access to the radiator cap.
26. Engine Exhaust Pipe — Directs engine exhaust to the
rear of the light tower. neveR block this exhaust pipe
with obstructions. ALWAYS place the light tower in an
area free of obstructions.
27. Left Brake/marker Light/License Light — Before
towing the light tower, make sure that this light is
operational and is working correctly. neveR tow the light
tower if this light is inoperative. This light also illuminates
the license plate.
28. Right Brake/marker — Before towing the light tower,
make sure that this light is operational and is working
correctly. neveR tow the light tower if this light is
inoperative.
29. Rear Jackstands/Outriggers — There is one jackstand
located at the rear of the trailer. Use this jackstand and
outrigger to level and support the light tower.
page 22 — LT6K LIgHT TOWeR • OpeRaTIOn manuaL — Rev. #2 (09/11/14)
24
25
26
29
REAR VIEW
Figure 5. Major Components (Front/ Rear)
31
28
33
30
30. Tires — This light tower uses a ST175-80D size tire.
Replace with only recommended tire size. neveR tow
light tower with bad or worn tires.
31. Left-side Ballast (Curbside) — crubsideThis area of
the light tower encloses the components for the ballast
assembly lights 1 and 3 (top).
32. Right-side Ballast (Roadside) — This area of the
light tower encloses the components for the ballast
assembly lights 2 and 4 (bottom).
33. Front Jackstands/Outriggers — There are two
jackstands located at the front of the trailer. Use these
jackstands and outriggers to level and support the light
tower.
34. Ground Point — Grounding requirements differ by
application, state, and agencies. If more definitive earth
to ground connections are required, see NEC guidelines
and use this established grounding point.
components
32
33
34
FRONT VIEW