Supermicro X13SEED-F User Manual page 65

Bootup NumLock State
Use this feature to set the Power-on state for the <Numlock> key. The options are On and Off.
Wait For "F1" If Error
Select Enabled to force the system to wait until the <F1> key is pressed if an error occurs.
The options are Disabled and Enabled.
INT19 Trap Response
Interrupt 19 is the software interrupt that handles the boot disk function. When this feature
is set to Immediate, the ROM BIOS of the host adaptors will "capture" Interrupt 19 at bootup
immediately and allow the drives that are attached to these host adaptors to function as
bootable disks. If this feature is set to Postponed, the ROM BIOS of the host adaptors will not
capture Interrupt 19 immediately and allow the drives attached to these adaptors to function
as bootable devices at boot up. The options are Immediate and Postponed.
Re-try Boot
When Extensible Firmware Interface (EFI) Boot is selected, the system BIOS will automatically
reboot the system from an EFI boot device after an initial boot failure. Select Legacy Boot to
allow the BIOS to automatically reboot the system from a Legacy boot device after an initial
boot failure. The options are Disabled, Legacy Boot, and EFI Boot.
Power Configuration

Watch Dog Function
Select Enabled to allow the Watch Dog timer to reboot the system when it is inactive for more
than 5 minutes. The options are Disabled and Enabled.
Watch Dog Action (Available when "Watch Dog Function" is set to Enabled)
Use this feature to configure the Watch Dog Time_out setting. The options are Reset and
NMI.
Front USB Port(s) (Available when the DCMS key is activated)
Use this feature to enable or disable front USB ports. The options are Enabled, Disabled,
and Enabled (Dynamic).
Rear USB Port(s) (Available when the DCMS key is activated)
Use this feature to enable or disable rear USB ports. The options are Enabled, Disabled,
and Enabled (Dynamic).
65
Chapter 4: UEFI BIOS