Impax IM-MIG120 Instruction Manual page 22

MIG ASSEMBLY (WITH GAS)
MIG Welding with GAS
Insert the cable plug with the earth clamp into
the "-" socket on the front panel of the welding
machine, and tighten it clockwise.
The MIG torch is permanently attached to the
connector socket on the front panel of the
machine.
Fig 2
1.0
0.9
WIRE 0.8
SELECTION
MIG
MMA
WELDING TIG
MODE
A
1 10
MIG Torch
Connect the welding power lead to the "+"
socket on the front panel of the welding
machine, and tighten it clockwise.
Connect the gas hose to the regulator /
flowmeter located on the shield gas cylinder (not
supplied) and connect the other end to the gas
inlet on the rear of the machine (Fig.2). Use the
hose clamps to secure the gas hose.
GAS IN
AC230V
GAS IN
Earth Clamp
21
ON
Gas
Hose
OFF