Using The Ac Adaptor; Inserting/Removing The Card (Optional) - Panasonic Lumix DMC-L1 Operating Instructions Manual

Using the AC Adaptor

You can use the camera without worrying
about battery discharge when it is
connected to a PC or printer if you use the
AC adaptor.
• Check that the camera is turned off.
• Close the flash.
1 Connect the AC cable.
2 Connect the DC cable A.
• Pull open the DC cable cover 1 and
then connect the DC cable to the
camera body using the same steps as
"Inserting/Removing the Battery" (P20).
Pull the DC cable through the opening
as shown in the illustration and then
close the battery door.
• Be careful not to catch the DC cable
when closing the battery door.
• Do not use any other AC adaptors except
the supplied one.
• Do not use any other DC cables except
the supplied one. If you use other DC
cables, it may cause a malfunction.
• The camera becomes warm during use.
This is not a malfunction.
• Disconnect the AC adaptor and DC cable
when the camera is not in use.
Inserting/Removing
the Card (Optional)
• Check that the camera is turned off.
• Close the flash.
• Prepare a card.
1 Slide the card door to open it.
1 2 Insert:
Insert the card fully until it clicks
A
and it is locked.
Remove:
Push the card until it clicks, then
pull the card out upright.
• Check the direction of the card.
Preparation
PU SH TO
LOC K / EJE
CT
21
VQT0W82