Step 2 Connecting - Sony VPL-FHZ91L Quick Reference Manual

Step 2
Notes
 Turn off all devices before making any connections.
Use the proper cables for each connection.

Insert the cable plugs firmly; Loose connections may reduce performance of picture signals or cause a

malfunction. When unplugging a cable, be sure to grip the plug, not the cable itself.
 For more information, refer also to the instruction manual of the device to be connected.
Connecting to a Computer
INPUT D
This terminal is used when connecting the projector to a computer with a HDMI output terminal.
Computer
Notes
 Use HDMI-compatible device which has the HDMI Logo.
 Use a high speed HDMI cable(s) on which the cable type logo is specified. (Sony products are recommended.)
 The HDMI terminal of this projector is not compatible with DSD (Direct Stream Digital) signal or CEC (Consumer Electronics
Control) signal.
Connecting to a Network Equipment
Using a LAN terminal
Computer
Notes
 When using network features via the LAN terminal, be sure to check if "LAN Setting" is set to "LAN Port".
 Connect the projector to the network that is constructed to control the access from the internet, such as LAN. If the
projector is connected directly to the internet, the security risk is increased.
When you monitor and control the projector via the network, access the Setup page of the projector (refer to "Using
Network Features" in the Operating Instructions) via a Web browser and enable the desired control protocol.
44
GB
Connecting
Connecting
HDMI output
terminal
HDMI cable
(not supplied)
LAN cable (straight type) (not supplied)
LAN
terminal
Hub, router, etc
INPUT D