Mounting Information; Declaration Of Conformity - D+H KA 66-TW1-K-BSY+ Original Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

Mounting information

Mount the drives mechanical stress-free.
With that, more even load distribu-
tion is ensured on all the drive
chains.
If after mounting, the measure X is as bigger as
23 mm, null balance with software SCS is
neccesary.
Closure Ranges will shift in relation to new zero
point.
≥ 23 mm ? X
Locking force adjustment
If factory-set locking pressure of approx. 150 N is not
sufficient to close the window, it can be infinitely
increased up to approx. 250 N.
Put in covering stopper after adjustment.
Locking force adjustment
Ø 6 mm
approx. 150 N
99.823.95 2.8/02/22
=
approx. 250 N
At vertical active pulling application (e.g. for a
skylight) the forces must be rearranged by
software SCS.
For option "IP 42": the chain outlet must not point
upwards.

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following
2014/30/EU, 2014/35/EU, 2011/65/EU
S.I. 2016/1091, S.I. 2016/1011, S.I. 2012/3032
Technical file at:
D+H Mechatronic AG, D-22949 Ammersbek
Dirk Dingfelder
CEO
01.03.2022
Disposal
Electrical devices, accessories, batteries and packa-
ging should be sorted for environmental-friendly
recycling. Do not dispose electrical devices and
batteries into household waste!
Only for EC countries:
According the European Guideline 2012/19/EU for
waste electrical and electronic equipment and its
implementation into national right, electrcal devices
that are no longer usable must be collected separa-
tely and disposed of in an environmentally correct
manner.
English
regulations
:
Maik Schmees
CTO
KA 66-TW-K
7/16

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ka 66-tw-k

Table of Contents