Table of Contents
Advertisement
Night: the camera stays at night mode.
Auto: the camera switches between the day mode and the night mode according
to the illumination automatically. The sensitivity ranges from 0 to 7, the higher the
value is, the easier the mode switches. The Filtering Time refers to the interval
time between the day/night switch. You can set it from 5s to 120s.
Scheduled-Switch: Set the start time and the end time to define the duration for
day/night mode.
Triggered by alarm input: The switch is triggered by alarm input. You can set the
triggered mode to day or night.
Smart Supplement Light: Set the supplement light.
Select Auto, and the supplement light changes according to the actual luminance.
E.g., if the current scene is bright enough, then the supplement light adjusts itself
to lower power; and if the scene is not bright enough, the light adjusts itself to
higher power.
Select Manual, and you can adjust the supplement by adjusting the distance. E.g.,
if the object is near the camera, the device adjusts the supplement light to lower
power, and the light is in higher power if the object is far away.
Backlight Settings
BLC Area: If you focus on an object against strong backlight, the object will be too
dark to be seen clearly. BLC compensates light to the object in the front to make
it clear. OFF, Up, Down, Left, Right, Center, Auto, and Custom are selectable.
Note:
If BLC mode is set as Custom, you can draw a red rectangle on the live view
image as the BLC area.
WDR: Wide Dynamic Range can be used when there is a high contrast of the bright
area and the dark area of the scene.
HLC: High Light Compression function can be used when there are strong lights in
the scene affecting the image quality.
White Balance
White balance is the white rendition function of the camera used to adjust the
Network Camera User Manual
102
Advertisement
Table of Contents
