Recording Check - Panasonic NV-GS11 Operating Instructions Manual

ª Recording Check
≥For Recording Check, the recording speed
mode (SP/LP) must be the same as the mode
used for the recording. If different, playback
images will be distorted.
ª Recording on a Card (NV-GS15 only)
≥Even if the [SHTR EFFECT] is set to [ON], the
Shutter Effect cannot be recorded on the
picture.
≥Pictures with wide-screen format signals cannot
be copied.
≥When the colour of the screen changes or blurs,
adjust the shutter speed manually to 1/50 or
1/100.
Photoshot
≥The sound cannot be recorded.
≥The file format supported by this Movie Camera
is JPEG. (Not all the JPEG formatted files will
be played back.)
≥If [NORMAL] or [ECONOMY] is selected for
recording, mosaic-pattern noise may appear on
a playback image depending on the image
content.
Continuous Photoshot
≥One more still picture may be recorded after
you release the [PHOTO SHOT] Button.
≥The Continuous Photoshot and Title Function
cannot be used simultaneously.
≥When the [SELF TIMER] is set to [ON], the
Movie Camera records the maximum number of
pictures recordable depending on the
[BURST MODE] setting.
≥When using the card formatted by other
equipment, intervals of recording pictures may
become large.
≥If recording or erasing pictures is repeated
many time, intervals of recording pictures may
become large. In this case, back up your
important data on PC, and format your card by
this Movie Camera.
≥Intervals of recording pictures may become
large depending on the card. We recommend
using Panasonic SD Memory Card.
ª Recording with the Built-in LED Video
Light
≥The subject should be within 1.5 metres of the
Movie Camera.
≥Using the LED Video Light reduces battery time.
≥Set the LED Video Light to off when not in use.
≥Do not look directly into the light.
≥If the LED Video light is used with a Conversion
lens attached, a slight vignetting (darkening
around edges) effect occurs on the screen.
≥Using the Night View Function at the same time
will make conditions even brighter.
Others
≥The LED Video Light enables to lighten simply
the images taken in a dimly-lit place. However
we recommend using it in a bright place in order
to obtain the high quality images.
ª Quick Start
≥During the Quick Start Standby Mode, a minute
amount of electricity is consumed.
≥When the Movie Camera is left in the Recording
Pause Mode for 6 minutes, it will be turned into
the Quick Start Standby Mode. To turn the
Movie Camera on again, set the [OFF/ON]
Switch to [OFF] and then set it to [ON] again.
(The Quick Start Mode will be restored.)
≥This Function is not activated in the following
cases:
≥Neither a card nor a tape has been inserted,
while the Tape/Card Recording Mode is set.
≥In the following cases, Quick Start is cancelled
during the Quick Start Standby Mode.
≥Operate the Mode Dial.
≥The Battery is replaced
≥If the [QUICK START] Button is pressed and
held for approximately 2 seconds during the
Quick Start Standby Mode, the Lamp will go off
and the Movie Camera will completely be turned
off.
≥If the Movie Camera is not operated for
approximately 30 minutes when the Quick Start
Recording Lamp lights, the Lamp will go off and
the Movie Camera will completely be turned off.
≥In the Automatic White Balance Mode, the
colour may be recorded unnaturally at the
beginning of the recording.
≥The zoom magnification differs from when it is
in the Quick Start Standby Mode and when the
recording starts.
ª Self-timer Recording
≥When [BEEP SOUND] on the [INITIAL]
Sub-Menu is set to [ON], the beep sound will be
emitted in the Self-timer Standby Mode.
≥By operating the [OFF/ON] Switch, Recording
Start/Stop Button or Mode Dial, the Self-timer
Standby Mode is cancelled.
ª Zoom In/Out Functions
≥When you are zooming on a faraway subject, a
sharper focus is achieved if the recording
subject is 1.2 metres or further from the Movie
Camera.
≥When you record pictures with 10k or more of
magnification, the Movie Camera is susceptible
to camera shake. We recommend using a
tripod.
-48-