Table of Contents
Advertisement
906993 - 11-01-02.qxd
11. Unplug charger from outlet before attempting any maintenance or clean-
ing – to reduce risk of electric shock.
12. Charge the battery pack in a well ventilated place, do not cover the
charger and battery pack with a cloth, etc., while charging.
13. Do not store the charger or battery pack in locations where the temper-
ature may reach or exceed 122°F (50°C) (such as a metal tool shed, or a car
in the summer), which can lead to deterioration of the storage battery.
14. Do not charge battery pack when the temperature is BELOW 40°F
(4.4°C) or ABOVE 104°F (40°C). This is very important for proper operation.
15. Do not incinerate battery pack. It can explode in a fire.
16. Do not charge battery in damp or wet locations.
17. Do not attempt to charge any other cordless tool or battery pack with the
Delta ShopMaster charger.
18. Do not short across the terminals of the battery pack: EXTREMELY
HIGH TEMPERATURES COULD CAUSE PERSONAL INJURY OR FIRE.
19. Double insulated tools
is wider than the other). This plug will fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install a polarized
outlet. Do not change the plug in any way. Double
Insulation
eliminates the need for the three wire
grounded power cord and grounded power supply
system.
20. Dispose of expended batteries properly. The
Delta ShopMaster Battery Packs contains recharge-
able, nickel-cadmium batteries. These batteries
must be recycled or disposed of properly. Drop off
expended battery packs at your local replacement
battery retailer, your local recycling center, or at a
Delta Service Center (see list on back page of this
manual). Applicable fees for the collection and recy-
cling of these batteries (in the United States), have
been paid to the RBRC
FOREWORD
Your Delta ShopMaster Drill/Driver is designed to drill holes and drive fasten-
ers in various materials as indicated in the following chart:
SPEED
RANGE
MILD STEEL ALUMINUM WOOD SELF-FEED BIT WOOD SCREWS
LOW
HIGH
SWITCH OPERATION
Squeeze trigger switch (A) Fig. 1, to start motor. Release trigger to stop motor.
As the trigger is squeezed the motor speed increases.
NOTE: A low volume, high pitched tone may be heard while the
switch is in the variable speed mode. This is normal.
11/1/02
3:51 PM
are equipped with a polarized plug (one blade
™
. For further information, call: 1-800-8-BATTERY.
FUNCTIONAL DESCRIPTION
MAXIMUM CAPACITIES
DRILLING
1/4"
1/4"
1/4"
1/4"
6
Page 6
RBRC™ is a Trademark of the
Rechargeable Battery Recycling
Corporation.
3/4"
3/8"
DRIVING
1/4"
#8
Advertisement
Table of Contents
