Table of Contents
Advertisement
906993 - 11-01-02.qxd
11/1/02
3:51 PM
Page 12
HORIZONTAL BUBBLE
A
LEVEL
The Model CL144 is equipped with
a horizontal level (A) Fig.9. The level
can aid in drilling a horizontal hole.
Fig. 9
MAINTENANCE
KEEP TOOL CLEAN
All plastic parts should be cleaned with a soft damp cloth. NEVER use sol-
vents to clean plastic parts. They could very possibly dissolve or otherwise
damage the material.
FAILURE TO START
Should your tool fail to start, make sure battery pack is charged and properly
installed in drill.
BATTERY
The battery pack will discharge by itself without damage if stored for long peri-
ods of time, and may require recharging before use.
LUBRICATION
For your continued safety and electrical protection, lubrication and service on
this tool should ONLY be performed by an AUTHORIZED DELTA SERVICE
STATION or a DELTA SERVICE CENTER.
At approximately 100 hours of use, take or send your tool to your nearest
Authorized Delta Service Station to be thoroughly cleaned and inspected;
worn parts replaced, when necessary; relubricated with fresh lubricant, and
performance tested.
SERVICE AND REPAIRS
All quality tools will eventually require servicing or replacement of parts due to
wear from normal use. These operations, including brush inspection and
replacement, should ONLY be performed by either an AUTHORIZED DELTA
SERVICE STATION or a PORTER-CABLE/DELTA FACTORY SERVICE CEN-
TER. All repairs made by these agencies are fully guaranteed against defec-
tive material and workmanship. We cannot guarantee repairs made or
attempted by anyone other than these agencies.
Should you have any questions about your tool, feel free to write us at any
time. In any communications, please give all information shown on the name-
plate of your tool (model number, type, serial number, etc.).
12
Advertisement
Table of Contents
