Maintenance By Unqualified Personnel; Service And Repairs; Troubleshooting - Igloo KING EVO Instruction Manual

• Wash the equipment with water of temperature not exceeding 40ºC with addition of neutral
detergents. It is forbidden to use cleaning agents containing chlorine and sodium in various
forms which destroy the protective coating and equipment components (also some grades of
stainless steel)! Possible residues of adhesives of silicone on metal parts may be removed only
with extraction naphtha (does not apply to plastic parts). Do not use other organic solvents.
• Do not clean the equipment with water jet, use a wet cloth.
• After washing, wipe the equipment dry and leave it to dry completely!
• During operation and maintenance take care not to damage the temperature sensor located on
the evaporator cover or another place.
• During maintenance take care not to damage the rating plate which includes important informa-
tion for service personnel and waste disposal contractors.

Maintenance by unqualified personnel

An interruption of equipment operation is recommended at least once a year in order to perform a detailed inspec-
tion, check the technical condition, correct operation and electrical wiring.

8.SERVICE AND REPAIRS

8.1.Troubleshooting

Refer to these Manual sections in case of any problems with starting or operation of the equipment to make sure the
equipment is used properly. If the problems persist, the hints below will help eliminate them.
Possible FAILURE
Equipment does not
work
Thermostat problems
16
. N
Possible CAUSE
Mains voltage and frequency different than
foreseen for the equipment
Power supply cable disconnected
Power supply cable damaged
Main switch on control panel is OFF
Main switch is ON, but the thermostat panel
displays:
CAREL: OFF and temperature blinking
alternatingly mean that thermostat is off and it
should be turned on
IGLOO: only two dots - thermostat is off and it
should be turned on
DIXELL: OFF message: thermostat is off
N
Suggested SOLUTION
See the rating plate. Connect the equip-
ment to correct mains
Connect the power supply cable
Remove the power supply cable from
the outlet, insulate and call authorized
service
Put the main switch to ON and check if
the thermostat is working
CAREL – Press
panel
IGLOO – Press
panel
DIXELL – Press
panel
z T XX z TX
on thermostat
on thermostat
on thermostat
NX IGLOO.PL
en